For electric water heaters only. Heavy-duty polypropylene. Dual size 1 to 1-1/2 in PVC drain fitting with gaskets included. Sides are 2-1/2 in deep. Pre-cut side opening for drain fitting.

For electric water heaters only. Heavy-duty polypropylene. Dual size 1 to 1-1/2 in PVC drain fitting with gaskets included. Sides are 2-1/2 in deep. Pre-cut side opening for drain fitting.

Test your elements and thermostats while still in the water heater. 1 piece.

Fits standard 1/2 in socket drive to replace screw-in water heater elements.

For gas or electric water heaters. Dual size 1 to 1-1/2 in PVC drain fitting with gaskets included. Sides are 2-1/2 in deep. Pre-cut side opening for drain fitting.

3 in x 48 in x 75 in vinyl faced fiberglass water heater insulation blanket, R value 10.0, fits up to 60 gal tank, plastic tape. For gas, oil or electric water heaters.

Plumb Pak Water Heater Connector, Nominal Size: 3/4 in, FIP x MIP Connection, Stainless Steel, 24 in L, Suitable for: Water Heaters

Places gas water heaters 18 in above floor as required by the National Fuel Gas and Plumbing Codes. Galvanized sheet metal of 18 ga thick holds up to 50 gal water heaters. Many local building codes require a water heater stand for gas water heaters located in areas where the accumulation of combustible fumes may occur.

Intermatic Water Heater Timer, Steel, 5 in Width, 7-3/4 in Height