|
|
|
|
|
|
|
|
|
|
|
|
|
|
The CAMCO side mount run-off tube carries water steams safely to the drain pan or drain, if T and P valve activates. Thermoplastic polypropylene run-off tubes present a rigid surface for gripping with standard wrenches and can be cut to length.
|
For electric water heaters only. Heavy-duty polypropylene. Dual size 1 to 1-1/2 in PVC drain fitting with gaskets included. Sides are 2-1/2 in deep. Pre-cut side opening for drain fitting.
|
For electric water heaters only. Heavy-duty polypropylene. Dual size 1 to 1-1/2 in PVC drain fitting with gaskets included. Sides are 2-1/2 in deep. Pre-cut side opening for drain fitting.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Richmond Element Wrench, Dual, SAE/Metric: SAE, Head Size: 1-1/2 in, 1-7/8 in, 5 in L
|
Test your elements and thermostats while still in the water heater. 1 piece.
|
Fits standard 1/2 in socket drive to replace screw-in water heater elements.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
For gas or electric water heaters. Dual size 1 to 1-1/2 in PVC drain fitting with gaskets included. Sides are 2-1/2 in deep. Pre-cut side opening for drain fitting.
|
3 in x 48 in x 75 in vinyl faced fiberglass water heater insulation blanket, R value 10.0, fits up to 60 gal tank, plastic tape. For gas, oil or electric water heaters.
|
Plumb Pak Water Heater Connector, Nominal Size: 3/4 in, FIP x MIP Connection, Stainless Steel, 24 in L, Suitable for: Water Heaters
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
The tankless drain pan is designed to fit underneath most whole house tankless water heaters providing both water damage protection and flushing maintenance convenience. The pans are injection molded to give them great strength and durability.
|
This wall-mount, aluminum tankless drain pan is designed to fit underneath most whole house tankless water heaters providing both water damage protection and flushing maintenance convenience. These aluminum pans will not rust, corrode or crack and may be used for gas or electric water heaters.
|
Places gas water heaters 18 in above floor as required by the National Fuel Gas and Plumbing Codes. Galvanized sheet metal of 18 ga thick holds up to 50 gal water heaters. Many local building codes require a water heater stand for gas water heaters located in areas where the accumulation of combustible fumes may occur.
|
|
|
|
|
|
|
|
|
|
|
|
|
Intermatic Water Heater Timer, Steel, 5 in Width, 7-3/4 in Height
|
|
|
