Pumps water level down to 3/8 in. Comes with compact 3/4 ID hose with 3-5/16 in high. For use with 12 VDC systems only. Outputs 600 gph at 0 deg rise. Will perform at reduced capacity up to 3 ft rise.

Replace ultra-flow bulb. Large alcohol compounded primer bulb for 3/8 in fuel line assemblies. Reduces flow restriction for maximum flow.

Fuel connector, male for OMC engines. Brass construction and 1/4 in NPT thread.

US Hardware Drain Plug, Stainless Steel, Suitable for: 1 in Dia Drain

Fits most engines with side water inlets. Flushes away sand, silt, salt and alkali. Prevents clogging and corrosion, extending the engine life. Installs in seconds without tools.

For OMC, Johnson and Evinrude. Features ultrasonically welded acetal. 3/8 in Barb.

Brass. For 1 in Dia drains.

For boats up to 39.4 ft length. Die-cast Zamak with perma-plate chrome finish. Light includes one 7.5 W lamp. Base is pre-drilled with two countersunk holes for #8 screws. Size 1-3/8 in x 2-3/4 in x 2-1/2 in.

Molded one-piece construction of white marine vinyl. Smooth, round shape assures fewer hull abrasions. Grommets are integrally molded into each end to allow easy vertical or horizontal use.

Die-cast Zamak? with perma-plate chrome finish. Base is pre-drilled for four #8 fasteners.

Cam-action neoprene plugs. Snap shut to form a leak-proof stopper for Livewells or Baitwells.

Plastic handle with black thermoplastic body. Rated for 5 A load, 15 A inductive load. 12 VDC only. 1-3/8 in x 3/4 in.

US Hardware Two-Position Switch, 2-Wire Marine, Specifications: 12 VDC, Chrome

All round light. Rubber storage clips hold pole when not in use. Nickel-plated brass finish washer suitable for up to #8 fastener.

Panel-mounted rocker switch for use with pump that draws 10 A or less. 1/4 in spade terminals. 6 V through 32 VDC only.

Features ultrasonically welded acetal.

Features ultrasonically welded acetal.

Features a swivel cover that protects the socket when light is stowed away. Socket is non-corrosive, plastic base extends just 3 in below deck when installed. Pre-drilled with three countersunk holes for #10 screws. 1-3/8 in hole Dia.

Die-cast Zamak? with perma-plate chrome finish. Base is pre-drilled for four #10 fasteners.

Pre-drilled to accommodate four #6 screws. Durable chrome-plated brass ring is small enough to fit on most hatches, cabinets and drawers.

Panel-mounted rocker switch for use with pump that draws 10 A or less. 1/4 in spade terminals. 6 V through 32 VDC only.

Brass. For 1 in Dia drains.

Cam-action neoprene plugs. Snap shut to form a leak-proof stopper for Livewells or Baitwells.

Features ultrasonically welded acetal.

Features brass construction.

One-mile side light, for boats up to 12 m length. Light with combination red/green lens is a popular choice for installation on bass boats.

Cast iron coated with thermal bond PVC vinyl. Non-toxic powder which helps it soak into the anchors.

Brass hose to connect two pieces of hose together.

Chrome-plated. 12 VDC only. Maximum panel thickness 1 in.

Designed to connect threaded parts to hose. Brass hose barbs. Thread size of 1/4 in NPT.